UH-18: Prep for mounting the duct.

My UH-18, getting ready to mount the duct. The foam is known to be fairly round. I rammed that into the hole so the prop won't touch it.

I used a funky little angle level (the orange thing) to make the duct angle be 30 degrees. I moved the stick around till it was on fairly straight and blocked up the front so it was as high as I wanted it.

This is the bottom of a different UH-18 hull. Finishing the foam work for the lift duct, with the craft upside down. I shot this to demonstrate working with foam.

	My UH-18, getting ready to mount the duct. The foam is known to be fairly round. I rammed that into the hole so the prop won't touch it.
	I used a funky little angle level (the orange thing) to make the duct angle be 30 degrees. I moved the stick around till it was on fairly straight and blocked up the front so it was as high as I wanted it.


	This is the bottom of a different UH-18 hull. Finishing the foam work for the lift duct, with the craft upside down. I shot this to demonstrate working with foam.